Hi! There are two ways on how to program your RCA Universal Remote Control. First is the direct code entry. In following these steps you need to provide me the type and brand of the device you want to be programmed to your remote control so I can give you the code for that certain device. Since you did not indicate the information I need for the code I will advise you to do the second way which is the Auto Code Search. Here are the steps for you to be able to program your Universal Remote without the code list.
1. Manually turn on the device you want to control. 2. Press and hold the device key you want to program. While you’re holding down the device key, use your other hand to press and hold the remote’s POWER key at the same time. 3. Wait until the remote’s indicator comes on and stays on. Then release both keys. 4. Point the remote directly at the front panel of the device you want to control. Press PLAY on the remote and wait 5 seconds. The remote is testing a batch of 10 codes on your device. Did your device turn off? YES: Go to step 5. NO: Press PLAY again. The remote tests the next batch of 10 codes. Keep pressing PLAY every 5 seconds until your device turns off. 5. When your device turns off, press the REVERSE key on the remote and wait at least 2 seconds. The remote tries the last of the previous ten codes. Did your device turn on? YES: Press the STOP key. You’re done! You’ve programmed this device key. NO: Press REVERSE again. The remote tests the next code in the batch. Keep pressing REVERSE every 2 seconds until your device turns back on. When it does, press STOP. Note: If you accidentally press the REVERSE key after your device turns on, press the FORWARD key. Then, wait two seconds to see if your device turns off again.
Answers & Comments
Hi! There are two ways on how to program your RCA Universal Remote Control. First is the direct code entry. In following these steps you need to provide me the type and brand of the device you want to be programmed to your remote control so I can give you the code for that certain device. Since you did not indicate the information I need for the code I will advise you to do the second way which is the Auto Code Search. Here are the steps for you to be able to program your Universal Remote without the code list.
1. Manually turn on the device you want to control.
2. Press and hold the device key you want to program. While you’re holding down the device key, use your other hand to press and hold the remote’s POWER key at the same time.
3. Wait until the remote’s indicator comes on and stays on. Then release both keys.
4. Point the remote directly at the front panel of the device you want to control. Press PLAY on the remote and wait 5 seconds. The remote is testing a batch of 10 codes on your device.
Did your device turn off?
YES: Go to step 5.
NO: Press PLAY again. The remote tests the next batch of 10 codes.
Keep pressing PLAY every 5 seconds until your device turns off.
5. When your device turns off, press the REVERSE key on the remote
and wait at least 2 seconds. The remote tries the last of the previous ten codes.
Did your device turn on?
YES: Press the STOP key. You’re done! You’ve programmed this device key.
NO: Press REVERSE again. The remote tests the next code in the batch. Keep pressing REVERSE every 2 seconds until your device turns back on. When it does, press STOP.
Note: If you accidentally press the REVERSE key after your device turns on, press the FORWARD key. Then, wait two seconds to see if your device turns off again.