Hello!!!! Here are some codes and the process of programming your remote to the tv. It is very quick and simple!!
1. Hold down the clear TV button until all lights light up at the top of the remote 2. Punch in a 3 digit code (provided below) 3. Press the # (POUND) button 4. Try powering the tv on/off, and the volume. If one or more of these functions do not work, start over from step 1 with a different code
There are two codes, the codes for Olevia are 126, 507. If neither code works try a Power Scan the steps are listed below. 1.) Hold the clear TV button until all four buttons at the top of the remote are lit press 500 then #. 2.) While at the TV locations (TV1 or TV2 depending on which key is installed), point the remote at the TV. 3.) Press and hold the TV MODE button on the remote until all four MODE buttons at the top of the remote light up. 4.) Press the RECEIVER POWER button on the remote 5.) Press the UP ARROW on the remote, about one press every two seconds. Stop as soon as the TV turns off. This process may take several minutes. 6.) Press POUND (#) on the remote. The TV MODE button will flash three times. 7.) Press TV POWER on the remote to turn on the TV. Press VOLUME on the remote to confirm the remote controls the TV. If this does not work, return to Step 1. Hope this helps!
Answers & Comments
Hello!!!! Here are some codes and the process of programming your remote to the tv. It is very quick and simple!!
1. Hold down the clear TV button until all lights light up at the top of the remote
2. Punch in a 3 digit code (provided below)
3. Press the # (POUND) button
4. Try powering the tv on/off, and the volume. If one or more of these functions do not work, start over from step 1 with a different code
578
580
564
Becki Barned
DISH Network Customer Service
Thank You so much! I looked everywhere for this code!
There are two codes, the codes for Olevia are 126, 507. If neither code works try a Power Scan the steps are listed below.
1.) Hold the clear TV button until all four buttons at the top of the remote are lit press 500 then #.
2.) While at the TV locations (TV1 or TV2 depending on which key is installed), point the remote at the TV.
3.) Press and hold the TV MODE button on the remote until all four MODE buttons at the top of the remote light up.
4.) Press the RECEIVER POWER button on the remote
5.) Press the UP ARROW on the remote, about one press every two seconds. Stop as soon as the TV turns off. This process may take several minutes.
6.) Press POUND (#) on the remote. The TV MODE button will flash three times.
7.) Press TV POWER on the remote to turn on the TV. Press VOLUME on the remote to confirm the remote controls the TV. If this does not work, return to Step 1.
Hope this helps!
Daniel Busa
DISH Network Customer Service