Press primer until fuel fills bulb and flows out carburetor. If no fuel in primer bulb then check connections.
Check fuel line connections by disconnecting retun line to tank (without filter) and pressing primer bulb. Fuel should draw from tank (filter), into bulb, out bulb to carb and expel out carburetor. If not the bad lines, filter, or lines not connected correctly.
With fuel primed, turn both high and low speed needles in (CW) until seated, do not tighten. Then turn needles out 1 1/2 turns for initial settings. These settings are only to get unit running. Increase idle speed setting if engine stalls. Adjust low speed, then high speed and lower idle speed back to normal.
Answers & Comments
Press primer until fuel fills bulb and flows out carburetor. If no fuel in primer bulb then check connections.
Check fuel line connections by disconnecting retun line to tank (without filter) and pressing primer bulb. Fuel should draw from tank (filter), into bulb, out bulb to carb and expel out carburetor. If not the bad lines, filter, or lines not connected correctly.
With fuel primed, turn both high and low speed needles in (CW) until seated, do not tighten. Then turn needles out 1 1/2 turns for initial settings. These settings are only to get unit running. Increase idle speed setting if engine stalls. Adjust low speed, then high speed and lower idle speed back to normal.