New install, used machine, need an old manual
I need to fill the hot water booster tank in an older model 401HT. I can find no booster fill switch anywhere. Is there a site with an install manual for an old discontinued model. Not the current 401HT+.
If the answer for filling the booster starts with "locate the booster fill switch", it's no good. There is none. Either the older 401HT has no booster fill switch, or the one in this model has been removed... or it has a switch but it is very hard to find. I haven't started to take the thing apart.
I'm afraid to turn it on without filling the booster tank with water. Thanks.
If the answer for filling the booster starts with "locate the booster fill switch", it's no good. There is none. Either the older 401HT has no booster fill switch, or the one in this model has been removed... or it has a switch but it is very hard to find. I haven't started to take the thing apart.
I'm afraid to turn it on without filling the booster tank with water. Thanks.
Dishwashers - Moyer Diebel - 401HT Dishwasher
Answers & Comments
I'm too late for you but others could be helped. With the power off' make sure the timing cams are set to the beginning of cycle, Then push the cams with a finger untill the fill cam switch just activates. Then put the power on,close and latch door and water should enter the booster. You might have to do this 2 times to get water at correct level inside machine. When the cycle lite goes off check for water inside machine. If water level is too high, then take some water out with a cup.