NO Light I have a h30, there is no light coming on the unit and the lamp trouble light is lit up. I replaced it with a bulb I had used before which I knew was good, and the same thing happen, is it possible that the bulb went bad sitting in storage of is there something else wrong with the unit? I don't want to spend $350 on a another bulb if my unit is porked. Is there any way to check the bulb or is it something else with the unit. Thanks
This is a tough one because the bulbs are so expensive.
Take your pick, bulb, main board or ballast board. Those are the three most probable culprits. I'm afraid you may have to send it for service (or at least an estimate).
FYI, did you know that projector bulbs are cheep, but point of sales mark them up by at least 300%?
Answers & Comments
This is a tough one because the bulbs are so expensive.
Take your pick, bulb, main board or ballast board. Those are the three most probable culprits. I'm afraid you may have to send it for service (or at least an estimate).
FYI, did you know that projector bulbs are cheep, but point of sales mark them up by at least 300%?
Our shop gets them for about $80.