No water entering dishwasher; motor running
Motor runs, never stops, regardless of where I set the dial. No water enters dishwasher, though it will empty if I manually add water to it. Doesn't turn off even when I set the knob at the Off positions. This happened when I tried to skip the drying cycle by turning the knob a couple clicks ahead near the end of the cycle.
I think that the oversudsing switch may have turned itself on. Last time I tried to skip the drying cycle, same thing happened; friend reset oversidsing switch and everything worked.
HOW DO I RESET THAT OVERSUDSING SWITCH?
Thank you!
I think that the oversudsing switch may have turned itself on. Last time I tried to skip the drying cycle, same thing happened; friend reset oversidsing switch and everything worked.
HOW DO I RESET THAT OVERSUDSING SWITCH?
Thank you!
Dishwashers - Danby - DDW1805W Designer Series Free-Standing Dishwasher
Answers & Comments
The water-inlet valve lets water enter the machine. First Check to see if the valve is getting water. Make sure it’s not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you get power to valve when unit is put into operation may take a couple minutes to start a fill. If you have power and it’s not clogged up replace the valve .If you have no power to the water inlet valve check float switch. This can be done by checking the continuity. There is a video of this at http://appliancehelponline.com/dishfloatwaterinletvideo.html this will walk you checking the water inlet valve and the float switch. It may be a different model but the testing procedure will be the same. You can also enter your model # for diagrams and illustrations for most models. All parts come with installation instructions.