off the LED that shows time, speed etc. It appears that power for the LED is generated by operating the bike. I have operated the bike but the LED just doesn't turn on. How do I get the LED to operate?
Cycling - Schwinn
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
The Airdyne bikes carry AA batteries in the mini computer console, you'll have to open up the back of the housing to replace them.
If that doesn't solve the problem.
Make sure the gap between the sensor and the fan wheel magnet is between 2 and 4mm.
Check all connections. Without removing the wire, remove the sensor from the mounting bracket and pass a hand held magnet over the surface of the sensor.
If a signal is received by the computer, remount the sensor and make sure the gap between the flywheel magnet and the sensor is between 2 and 4mm.
If no signal is received by the computer, use a MultiMeter to check the continuity of the sensor and then the sensor wire.
If both the sensor and wire are functioning, replace the computer.
If you need any further assistance please do not hesitate to call us @ 888-713-2880
Or check out our Tech Support Center online @ http://www.sportsmith.net/productsearch.aspx?dsNav=N:10000,Nrc:id-10000-dynrank-disabled