On the error code list, I'm getting an error code of Open Rollout, How do you fix that?
New Ignition Plug, Cleaned the Flame sensor, New filter, Power is going to where it needs to go as far as I know,
Heating & Cooling - Goodman - GDS80904BNA Open Flame Heater
Answers & Comments
A 'roll-out' safety switch it a small button looking device with a smaller tab/button sticking out of it, near the gas injection manifold. has 2 wires attached. the reset button is generally between these wires. it's designed to shut the unit off, by breaking the power circuit, if flame ignition causes fire to back flash out of the fire box. Press the little button and try relighting. if the roll-out pops again, and there was no roll out of flame, you made need to replace it.
"the roll-out safety switch is still in place and has not popped out and has been tested with the volt meter and is testing good? what now"
Add a Com"the roll-out safety switch is still in place and has not popped out and has been tested with the volt meter and is testing good? what now"ment