I had a customer with the very same trouble just recently. The problem turned out to be a bad pre-heat board located on top of the range just under the right side burner drip pans. The cause of the pre-heat board failure was a bad relay behind the louvered panel just under the oven door. It was pretty obvious the relay was bad in this case as the relay was swelled and burned. Also, be sure to check the grey wire on that relay the other end of the grey wire goes to L2 on the selector. Good Luck.
Answers & Comments
I had a customer with the very same trouble just recently. The problem turned out to be a bad pre-heat board located on top of the range just under the right side burner drip pans. The cause of the pre-heat board failure was a bad relay behind the louvered panel just under the oven door. It was pretty obvious the relay was bad in this case as the relay was swelled and burned. Also, be sure to check the grey wire on that relay the other end of the grey wire goes to L2 on the selector. Good Luck.
Either a relay board or a double line relay.
Range repair in Mission Viejo, CA
Appliance repair in Mission Viejo and Orange County, CA