Part of treadmill buttons won't work?
Won't start up BUT After being unplugged for a dayand everything is cooled off plug it back in and most of the time all the buttons beep and work properly for about 1 or 2 minutes and then quit working and beeping when pushed. If you started the treadmill and have it running before that 1 minutes is up it will stay running until you hit the stop button but will not start back up. The STOP button and the incline down button will always beep but no other button that would start anything going will work. It is like the power feed to the start, speed, and incline up buttons all go dead. Unplug for a day and will work again most of the time, not 100% of the time. The red light is on on the controller and it blinks when the machine is running, I believe that is normal. What do you think?
Exercise & Fitness - HEALTHRIDER - T650I Treadmill Front Roller Model Number HTL93940 Pa
Answers & Comments
Remove the control panel and try to clan the board using isopropyl alcohol using a brush. Leave the board for one day so that it would get dry. Then install the control board back and check and check it. Sometime moisture acclimated on the control panel can cause such problems . If you didn't get isopropyl alcohol then put the control board in sunlight for one or two days. Then install the control panel and check whether it works or not. also try to replace all the switches on control panel board. you will get it in any electronic spare parts shop.Beside not to put it on direct sunlight it can cause problems to the display
If you wish to get some more details about treadmill repair and service then check the following link.
http://electro-medical.blogspot.com/