Pilot light wont stay lit
When I hold down the button and light my pilot and hold for 30 seconds like the directions say then when i release it it goes out and i cant turn the nob to the on position. Any ideas?
Pool & Spa - Teledyne Laars - Laars Lx Pool Heater / 400,000 Btu / Propane Gas
Answers & Comments
///SOLUTION NEEDED!///
pilot is lit...and stays lit - temp knob is up...and switch is on. It just wont ignite the burner... I relize that voltage source isn't clear to me as where the power supply comes into the unit .. not visiable! what should a multimeter pick up for voltage ???? model #DR-175 Teledyne Laars Propane (LP) Mark V// input 166,btu/hr.// output 116,2 btu/hr Thank you.. Jo- [email protected] & Happy New Year
If this is a new item then you will need to let the gas run alittle bit longer. If this is a used item then it sounds like you are going to need to replace the flame sensor. You may have to even do it on the new item. But usually for the first start you willl need to hold the pilot down for about 1 minute to really let things heat up in there then when you release all will work