Power problem when I turned the unit on, the service light was blinking,then went out, now there is no power at all. The batteries are fully charged
Health & Beauty - Invacare - Pronto M51 Power Wheelchair
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Push reset button to reset!
Try the service guide in the following link. I would try unplugging chair from power unplugging battery from chair letting site for a bit. Make sure chair is in neutral then replace battery and make sure to look for safety switch etc. usually under the seat. (someone usually need to be sitting in chair for it to operate. )
Hope the service manual helps. Any more questions just ask.
Service GUIDE
make sure break is engaged as well
The guide sent you is the actual service tech guide.
Hi!
This is the manual for your Invacare. Please refer to pg 26 on the manual to find out the what does diffrent blinking patterns indicate---
http://www.invacare.com/doc_files/1125085.pdf
Thanks
Rylee
Check out from pg 25 to 28. It will definetly solve your problem.
Ask for any clarifications.
The circuit breaker needs to be reset... i just can't locate where it is on that model.
Robert