The printer is indicating that the paper path has been changed (either via the control pannel on the printer or by escape command) to the single sheet feeder. I guess you are using Continuose Paper fed into the tractors at the front of the printer (Tractro 1), if this is the case you need to go into the menu on the printer and change the paper path back to Tractor 1.
Take the printer off-line by pressing the Online key Press the Setup key Press the key under "Paperway" in the display Select Tractor 1 Press the key under "Set"
This should change the peer path to the front Tractor, if this does not work power the printer OFF and disconnect it from the computer system. Then power the printer back on again and again try changing the paper path as described above. If you get the message LOAD SINGLE only when you send data to the pritner you need to check the paper path selected on the computer system.
Answers & Comments
The printer is indicating that the paper path has been changed (either via the control pannel on the printer or by escape command) to the single sheet feeder.
I guess you are using Continuose Paper fed into the tractors at the front of the printer (Tractro 1), if this is the case you need to go into the menu on the printer and change the paper path back to Tractor 1.
Take the printer off-line by pressing the Online key
Press the Setup key
Press the key under "Paperway" in the display
Select Tractor 1
Press the key under "Set"
This should change the peer path to the front Tractor, if this does not work power the printer OFF and disconnect it from the computer system. Then power the printer back on again and again try changing the paper path as described above.
If you get the message LOAD SINGLE only when you send data to the pritner you need to check the paper path selected on the computer system.