Perform these operations: Test->Diag->Clear->NVRAM Test->Diag->Clear->Cal>Then re-calibrate the printer. Procedures: Turn ON the Tech Access feature (hold ENTER and LINE FEED keys depressed approx. 5 seconds - until printer "beeps") Turn ON the Fault Override feature (hold ENTER and FORM FEED keys depressed approx. 5 seconds - until printer "beeps") Press the MENU key then UP Arrow to Offline - Test Menu Press ENTER then UP Arrow to Test Menu - Diag Press ENTER then UP Arrow to Diag - Calibrations Press ENTER then UP Arrow to Calibrations - Print Engine Cal Press ENTER and follow the instructions on the display Turn OFF the Fault Override feature by holding the ENTER and FORM FEED keys depressed until the printer "beeps" Turn OFF the Tech Access feature by holding the ENTER and LINE FEED keys depressed until the printer "beeps"
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Perform these operations:- Test->Diag->Clear->NVRAM
- Test->Diag->Clear->Cal>Then re-calibrate the printer.
Procedures:- Turn ON the Tech Access feature (hold ENTER and LINE FEED keys depressed approx. 5 seconds - until printer "beeps")
- Turn ON the Fault Override feature (hold ENTER and FORM FEED keys depressed approx. 5 seconds - until printer "beeps")
- Press the MENU key then UP Arrow to Offline - Test Menu
- Press ENTER then UP Arrow to Test Menu - Diag
- Press ENTER then UP Arrow to Diag - Calibrations
- Press ENTER then UP Arrow to Calibrations - Print Engine Cal
- Press ENTER and follow the instructions on the display
- Turn OFF the Fault Override feature by holding the ENTER and FORM FEED keys depressed until the printer "beeps"
- Turn OFF the Tech Access feature by holding the ENTER and LINE FEED keys depressed until the printer "beeps"