PS): Foxconn- TSAA-725 . The problem is that the case has a Power led connector which doesn't fit with the module on the board. It like CASE: 10, MB: 1-0. "-" stays for a space between them. Any solution?
So, the M/B has a 3 pin connector, but your case only has a 2 pin connector? Easiest way is just to cut the connector from the case in half with a pair of sissors.. It isn't the most nice solution, but it works quite well!
Answers & Comments
So, the M/B has a 3 pin connector, but your case only has a 2 pin connector? Easiest way is just to cut the connector from the case in half with a pair of sissors.. It isn't the most nice solution, but it works quite well!