There are a few questions:

What kind of cable do you use?
USB, SERIAL, PS2

What kind of computer?
Normal computer or Laptop?

Then...

When you recieve the scanner like new you always have to program it.

First you do

Reset to factory defaults.... Never do this with working scanners

then

you have to program it.

First the Connection type
and then if needed a computer type.

After that you usually have to scan a suffix.

This means when you scan a barcode it needs to do something after.

normally it doesn't give Enter after you scan.
That is what the suffix is for.

and then you scan additional symbologies to scan

Like Code 39, UPC A etc. etc.

It needs to be programmed with the manual you recieved.
if you don't have it you can download here.

goovy75

Ah is see.



So the scanner is connected to the extra port on the scale by RS232 or a serial connection.



The toledo scale is connected to the pc with ps2.



In this case you have to program the scanner by cable type rs232.



usually it's



baudrate 9600

no parity

1 bit parity.



First i would go to this manual.

goovy75

sorry when i said 1 bit parity. i meant 1 Stop bit not 1 bit parity sorry when i said 1 bit parity. i meant 1 Stop bit not 1 bit parity

Ir 6000 code e000246-0005 solution