Radio receiver which has a total of 6 outputs (RCA type). Two are "front", two are "rear", and two are for the sub-woofer. I have a sub-woorer, also new. My problem is, I have a Jensen 760 amp which has only 4 RCA inputs, labeled Channel-1, -2, -3, and -4. How do I get the inputs from the radio into the amp??
Car Audio & Video - Audiovox - Jensen Power 760 Car Audio Amplifier
Based on your statement, I can see that the Jensen 760 is lacking of two RCA type of inputs, right?
If that is the case, you may need to use an RCA port splitter. Using the splitter will allow you to have two additional RCA ports. You may need to buy two RCA splitters.
Answers & Comments
Based on your statement, I can see that the Jensen 760 is lacking of two RCA type of inputs, right?
If that is the case, you may need to use an RCA port splitter. Using the splitter will allow you to have two additional RCA ports. You may need to buy two RCA splitters.
Check the link below to see the pictures:
http://www.amazon.com/s?ie=UTF8&rh=n%3A172282%2Ck%3Arca%20splitter&page=1
Thank you and good luck!