If there fork tool remover is not doing the job as the ball has fallen apart then get a threaded bar ,a nut and a piece of tube. screw the nut about 1/2 way up the bar fit the tube over the bar and place the tool between the top and bottom ball joints. screw the nut down until pressure is exerted on the ball thread you wish to remove Hit the area of the ball taper and the joint will fly out.
Answers & Comments
If there fork tool remover is not doing the job as the ball has fallen apart then get a threaded bar ,a nut and a piece of tube. screw the nut about 1/2 way up the bar fit the tube over the bar and place the tool between the top and bottom ball joints. screw the nut down until pressure is exerted on the ball thread you wish to remove Hit the area of the ball taper and the joint will fly out.