Push off electrical connector and then there is a philips screw going down into the housing, unscrew that and then squeeze the two side tabs of the switch (left and right inside the cover) and it should pop out. Replace the switch and don't forget to put the screw in as it is the other side of the circuit and if you do not replace it, the saw will not stop.
Answers & Comments
Push off electrical connector and then there is a philips screw going down into the housing, unscrew that and then squeeze the two side tabs of the switch (left and right inside the cover) and it should pop out. Replace the switch and don't forget to put the screw in as it is the other side of the circuit and if you do not replace it, the saw will not stop.