Replaced a Dish VIP722 with the new VIP722k,--got new remotes, also have a Bellvu 3100 on same primary TV. Used to be able to use one remote to control either recever boxes. How to I add the 3100 to the new remote?
Televison & Video - DISH Network - IR Remote Control
If you are using the remote to operate an IR frequency, you can program that component to the VCR or AUX button on the new remote. I have provided the instructions on how to program the remote. I hope this helps.
Address To 2nd IR Receiver Using AUX Mode
Remote: 3.4, 4.4, 5.3, 5.4, 6.3, 6.4, 20.0, and 21.0
Go to 2nd IR receiver
Go to System Info Screen
Hold down the AUX button until all mode lights light up.
Press 3 then enter a number between 1 and 15 using the numeric keypad on the remote.
Press the pound (#) button
Once the AUX button blinks three times, press record. Note: If successful the number selected in step 4 will appear in the System Info screen under Remote Address.
Answers & Comments
D1032d_junk3
- Remote: 3.4, 4.4, 5.3, 5.4, 6.3, 6.4, 20.0, and 21.0
- Go to 2nd IR receiver
- Go to System Info Screen
- Hold down the AUX button until all mode lights light up.
- Press 3 then enter a number between 1 and 15 using the numeric keypad on the remote.
- Press the pound (#) button
- Once the AUX button blinks three times, press record. Note: If successful the number selected in step 4 will appear in the System Info screen under Remote Address.
If you are using the remote to operate an IR frequency, you can program that component to the VCR or AUX button on the new remote. I have provided the instructions on how to program the remote. I hope this helps.
Address To 2nd IR Receiver Using AUX Mode
Ray Calo
DISH Network