Nice double post, back up one and read. but now adds MANUAL. so the reverse switch is bad, remove it ,2wire switch and put in new.
its just a simple Thomas Edison switch, (no electronics) nothing magic. the FSM< covers this, (factory service manual) as does alldata.com if an OHM meter (resistance low range) shows infinity in reverse its bad, if reads 0 ohms its good, so if good, the wires to it were bad. or both lamp out, (can happen, ignored)
Answers & Comments
Nice double post, back up one and read.
but now adds MANUAL.
so the reverse switch is bad, remove it ,2wire switch
and put in new.
its just a simple Thomas Edison switch, (no electronics) nothing magic. the FSM< covers this, (factory service manual) as does
alldata.com
if an OHM meter (resistance low range) shows infinity in reverse its bad, if reads 0 ohms its good, so if good, the wires to it were bad.
or both lamp out, (can happen, ignored)