Inside the iron is a thermal switch that has failed to make contact. Dissassemble the iron and you will see a small white ceramic pin sticking up out of the heating chamber and on tip there is a small contact. Above it is another contact that makes the heating element work. Easiest way to fix is to put a small bead of glue on the housing to force the contacts together.
This is a problem with a lot of Rowenta irons. It is the auto shut off that is not working properly and the only way to fix it is to have it disassembled and the switch hardwired to be on whenever the iron it plugged in. It is a thermal metal switch and it just stops working and then the iron will not turn on and the yellow light blinks. This is a problem with a lot of Rowenta irons. It is the auto shut off that is not working properly and the only way to fix it is to have it disassembled and the switch hardwired to be on whenever the iron it plugged in. It is a thermal metal switch and it just stops working and then the iron will not turn on and the yellow light blinks.
I realize this post is now almost 8 years old but I thought I'd still give a try. Do you have an image or some other guidance on locating the ceramic pin on a Rowenta DW 9280? I've taken it apart and found a tiny metal ball rolling around inside. I'm assuming that's the small contact from the tip. My iron would do everything but heat up, i.e. light up, etc.I realize this post is now almost 8 years old but I thought I'd still give a try. Do you have an image or some other guidance on locating the ceramic pin on a Rowenta DW 9280? I've taken it apart and found a tiny metal ball rolling around inside. I'm assuming that's the small contact from the tip. My iron would do everything but heat up, i.e. light up, etc.
Answers & Comments
Inside the iron is a thermal switch that has failed to make contact. Dissassemble the iron and you will see a small white ceramic pin sticking up out of the heating chamber and on tip there is a small contact. Above it is another contact that makes the heating element work. Easiest way to fix is to put a small bead of glue on the housing to force the contacts together.
This is a problem with a lot of Rowenta irons. It is the auto shut off that is not working properly and the only way to fix it is to have it disassembled and the switch hardwired to be on whenever the iron it plugged in. It is a thermal metal switch and it just stops working and then the iron will not turn on and the yellow light blinks.
I realize this post is now almost 8 years old but I thought I'd still give a try. Do you have an image or some other guidance on locating the ceramic pin on a Rowenta DW 9280? I've taken it apart and found a tiny metal ball rolling around inside. I'm assuming that's the small contact from the tip. My iron would do everything but heat up, i.e. light up, etc.