Hi Mirran

Zivio and thanks for trying to help.

Below is what I sent and you sent.

the problem is that the Incanto I have has only one screw in the grinder and when you take theat off I can not get to the grinder parts to clean them. I have tried vacuuming the grinder area out and then put it all back.. It worked allright for a little bit and now is a problem again. I can send you photos of the machine and how far I got but how do I send this to you so you can see ?

thanks

Zlatko


Hi

My incanto classic is 2 years old. The add bean light comes on when I try and make a coffee. The grinder goes on but no coffee comes out and some ground coffee goes into the dreg drawer. I found in the past if I moved the beans around while the grinding started it did help a little and a coffee was made. Now I do this about 6 times and no good. Help please Mirran

Hi,

First, make sure you not get any damp into your grinder.
If you get damp into the grinder then it will not grind the beans.

To check the grinder you have to loosen the three screws in the beanhopper and lift it up.
The jagged plastic in the machine you will see when the beanhopper is off, turn it anticlockwise to you can see
the claque is free, then you can take out the jagged plastic and you will see the grinding wheel, make sure the wheel and the jagged plastic is clean.

Before you mount all again, use a vacuum cleaner to clean it.

Put back the jagged plastic again and turn it clockwise to it stop, then you turn it anti clockwise 14"click".
Set the number to 8 on the beanhopper and mount it again.

Hope this will help you.

Best regards
/Mirran

Coffee Makers & Espresso... - Saeco - Incanto Classic Espresso Machine