Saniplus- after flushing wc, motor continues to run and run
To stop the motor, the mains has to be switched off. Sometimes when emptying the bath, the motor will switch off normally.
Home - Saniflo - & Saniplus& Macerator Pump
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
The non return valve that is installed at the lip of the outlet from the unit has been jammed open. Usually it gets jammed with residue and or a build up of sludge. This permits a backflow of the pumped water back into the unit. It pumps it again and within a few seconds the waste/water flows back into the unit. Open it up (the outlet pipe) and clean it making sure the non return valve (it is a rubber hinged cap) moves freely.
See diagram here (last page of PDF):
Saniplus repair instructions
I should have mentioned that in the diagram Items 21a and 21b make up the non-return valve. It will make sense once you disconnect the main outlet and see the parts. Be careful, there will be water/waste in the outlet pipe so be prepared with a small bucket and paper towels.
Climatizarea nu functioneaza in sensul ca nu am aer rece ci doar aer cald