SC (fiber connected with each other) behind the "remote" FS713FC i have one motorola acces point (192.168.1.48 motorola ap5131). This AP functions properly. I added a second AP (192.168.1.45 motorola 5131). AP functions ok but after a while (hours-day? not sure) i can not ping 192.168.1.45. I replaced the new ap with a netgear Access Point (same address 192.168.1.45). Functions ok. Again after a while con not ping 192.168.1.45
Computers & Internet - Allied Telesyn - AT - AT-FS713FC ST-10 (at-fs713fc/st-10) Networking Switch
Answers & Comments
You got to check a few things prior to perform any troubleshooting step.
1)whenever you face a disconnection check both end FO converters and try to figure out which one lights are blinking and which are not blinking in both ends at the same time.
2) are both the converter is similar make or not? If not please specify both makes.
3)How many devices are connected on both end after the AP's(approx)? Is there any switch or hub also present within the same network?
4)whenever you face a hang/disconnection position disconnect and reconnect power from one of the FO converters and see what happens then disconnect and reconnect power in the other end and see what you get.
Please revert back with the above detail and I feel I will be able to help you out.Rather you will be able to find out where the issue lies by applying the above steps.
All the best.