Setting top of form for zebra 2844
How do I set the top of form for the label printer...when it advances it goes a little too far so when I tear a label off it tears the 1st 1/4 inch of the next label also
Office Equipment & Supplies - Zebra - TLP 2844-Z Thermal Label Printer
Answers & Comments
Hold down the green button, then power on. As soon as the light turns red, release the button. The printer will go into calibration mode. When complete, press the green button one more time.
i have the same problem but calibration did not solve the problem. i still need a solution for this
Do you still need help I own this printer?