Sound but no picture!
Hi slinterior
i took off the three plugs from the board that were red, blue, green and i assume that these were the convergence plugs you were talking about. the tubes on the bottom of the tv still glows and nothing is produced from the three lenses and when you look at the front of the set, there is no channel indicator nor is the menu format lit up on the screen, the set worked perfect before taking it apart except for the set turning off within 45 minutes and the picture not converged properly. can you give me any more info?
thanks
denny
i took off the three plugs from the board that were red, blue, green and i assume that these were the convergence plugs you were talking about. the tubes on the bottom of the tv still glows and nothing is produced from the three lenses and when you look at the front of the set, there is no channel indicator nor is the menu format lit up on the screen, the set worked perfect before taking it apart except for the set turning off within 45 minutes and the picture not converged properly. can you give me any more info?
thanks
denny
Televison & Video - Panasonic - PT-51HX41 51" Rear Projection Television
Answers & Comments
I would double check the wire connections especially the bridged connectors that connect the A and D boards also see if the wire from the front panel PCB is actually hooked up. Often its easy to get a wire plug mixed up and plugged into the wrong socket or not seated properly.
Youre welcome. Glad I could help you out.
HELLO ! I have a Panasonic PT51HX41E the TV was working perfectly until i moved it from one room to another. I can hear the sound but i cant see the picture. Wierd.. I tried the reset factory but it didn't work. I have tried changing the tv input but it doesnt work all i can hear it the white noise until i reach the input and i can then hear the sound of the TV but i cant see the picture. I oppened from the back i i saw 3 lamps on the bottom. They are all glowing but that about it. Has anyone had the same problem? PS I tried to put the tv on a table so i was taller but i couldn't lift it all the way because it was to heavy. ALL i did was lift one side about 30 degrees and put it gently back on the floor. Did i screwed something by trying to lift it from one side?