ST6000 controlhead shows full display with all segments when switched on and does not change when pressing various control buttons Thanks, wilhelm [email protected]
Raymarine told me the unit was faulty. I stripped and found corrosion on one side of the circuit board. After cleaning it worked again. I suspect there is probably corrosion on the other side of the board as well but not sure how to acces it. Afraid to break the CB trying to remove from housing
Answers & Comments
Raymarine told me the unit was faulty. I stripped and found corrosion on one side of the circuit board. After cleaning it worked again. I suspect there is probably corrosion on the other side of the board as well but not sure how to acces it. Afraid to break the CB trying to remove from housing