This is a very frequent problem with scale. Despite that the steam water knob is tightly closed, due to scale deposits one steam water valve, the valve cannot close completely. So when you press for coffee there is a steam-water leak from the wand too.
So you just need to perform de-scaling of the machine two - three times one every day and try to draw out the dissolve water and de-scaling solution in steps with 5 -10 minutes interval. This will give more time to the solution to dissolve the sale build up in your machine.
If after three de-scale performs you still have the problem then you need to disassemble the steam valve and manually remove the scale with a sharp tool and wire brush.
There is a small possibility that you might need to replace some parts in the valve all the whole valve.
You can find all the parts you may need, de-scale solution and many other information for your machine like manuals, diagrams at the
I don't know if you have visit the http://www.partsguru.com/
They have international sales.
In addition if you are only after the two 'o' rings then you can also try a DIY and they have sets of 'o' rings of various sizes and if you have the one you can match it and they will fit perfectly to your machine.I don't know if you have visit the http://www.partsguru.com/
They have international sales.
In addition if you are only after the two 'o' rings then you can also try a DIY and they have sets of 'o' rings of various sizes and if you have the one you can match it and they will fit perfectly to your machine.
Answers & Comments
This is a
very frequent problem with scale. Despite that the steam water knob is tightly
closed, due to scale deposits one steam water valve, the valve cannot close completely.
So when you press for coffee there is a steam-water leak from the wand too.
So you just
need to perform de-scaling of the machine two - three times one every day and
try to draw out the dissolve water and de-scaling solution in steps with 5 -10
minutes interval. This will give more time to the solution to dissolve the sale
build up in your machine.
If after
three de-scale performs you still have the problem then you need to disassemble
the steam valve and manually remove the scale with a sharp tool and wire brush.
There is a
small possibility that you might need to replace some parts in the valve all
the whole valve.
You can
find all the parts you may need, de-scale solution and many other information for
your machine like manuals, diagrams at the
http://www.partsguru.com/
I don't know if you have visit the http://www.partsguru.com/
They have international sales.
In addition if you are only after the two 'o' rings then you can also try a DIY and they have sets of 'o' rings of various sizes and if you have the one you can match it and they will fit perfectly to your machine.