If a “Table Mismatch” is displayed, recycle power and reflash the printer. Can get “Table Mismatch” after replacing CMX Board. “Table Mismatch” Flash Upgrade Instructions Using the printer’s Parallel Port: You have ethernet, you can FTP download. 1. Print a configuration on the printer prior to the download. After the flash is upgraded, the printer will be at Factory settings and you will need this printout to restore any non- default settings. 2. The PTX flash code is on a CD you should have received with printer. Don’t have? I can email you the Flash program. 3. Turn the printer's power off. 4. If there is a cable connected to the printer’s serial port, disconnect it. 5. Connect a cable from the LPT1 port on a PC that has a DOS prompt mode to the printer’s parallel port. 6. While holding down the Online & FF(Paper Advance) keys, power up the printer. The printer will display "Waiting for Program Download". 7. At the PC’s DOS prompt, go to the directory where the file is located C:\Temp and type "filename.exe -pb<ENTER>" where filename is the name of the file that you downloaded in step 2. NOTE: there is a space before the -pb 8. The printer's display will keep you informed of the status of the download. When the download is complete, cycle the printer’s power.
Answers & Comments
This is the only Solution to "Table Mismatch"...
If a “Table Mismatch” is displayed, recycle power and reflash the printer. Can get “Table Mismatch” after replacing CMX Board.
“Table Mismatch”
Flash Upgrade Instructions Using the printer’s Parallel Port: You have ethernet, you can FTP download.
1. Print a configuration on the printer prior to the download. After the flash is upgraded, the printer will be at Factory settings and you will need this printout to restore any non- default settings.
2. The PTX flash code is on a CD you should have received with printer. Don’t have? I can email you the Flash program.
3. Turn the printer's power off.
4. If there is a cable connected to the printer’s serial port, disconnect it.
5. Connect a cable from the LPT1 port on a PC that has a DOS prompt mode to the printer’s parallel port.
6. While holding down the Online & FF(Paper Advance) keys, power up the printer. The printer will display "Waiting for Program Download".
7. At the PC’s DOS prompt, go to the directory where the file is located C:\Temp and
type "filename.exe -pb<ENTER>" where filename is the name of the file that you downloaded in step 2.
NOTE: there is a space before the -pb
8. The printer's display will keep you informed of the status of the download. When the download is complete, cycle the printer’s power.
can you forward me the Flash Program to my email, [email protected]
And guide me how to flush the program