Engine is on a Craftsmen Yard Vac.Removed base plate to replace gasket and the camshaft fell out.I see a mark on the cam gear but not on crank or crank gear.I Need to know proper alignment ,also on the bottom of the camshaft there is a plastic "banjo" shaped piece with a steel rod with ball end on it,It appears to be there to pump oil thru the camshaft,where it slides over the cam one side is tapered in,the other flat,which side goes toward the base plate? Lastly, any special alignment for the governor gear? I HAVE TAKEN THIS ENGINE APART ABOUT 4 TIMES AND CANNOT FIGURE OUT HOW TO DO IT THE RIGHT WAY CAN ANYONE TELL ME HOW ????? E-MAIL ME AT [email protected] .,...... THANKS!!!!!!!!!!!!!!! IT IS A TECHEHM GO-KART ENGINE 6.5 HORSE POWER.

Toys - Razor - 300001-SL Ground Force Go Kart