The manual says wire black to black and white to white and ground to green screw. The box i am wiring into has a white a black a ground and a red. What do I do with the red wire?
Home Security - Heath Zenith - All Metal Motion Sensor Light Control, 270;, Detection Zone,...
Answers & Comments
Depending on where box is and who wired it the red wire very well may be switched from inside. If you want to use the dusk on and off and sensor exclusively, in other words, you don't want it switched, cap off the red wire and don't use it. If you would like it switched, see if you can find a switch that will operate the red wire, probably somewhere around the nearest doorway out, or if you have a switch that you could never figure out what it was for.
It's also possible that one of the boxes in near proximity of the switch may have a disconnected or loose wire in it which can be used as the switch leg.