1) Error - "SI2 At Power Up" Symptom: Indicates the OVP (Over Voltage Protection) circuit on the controller is active and belt will not move. 2) An SI-2 is basically a code that causes the treadmill to shut down. This is generally caused by a fluctuation in the treadmill
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
1) Error - "SI2 At Power Up"
Symptom:
Indicates the OVP (Over Voltage Protection) circuit on the controller is active and belt will not move.
2)
An SI-2 is basically a code that causes the treadmill to shut down. This is generally caused by a fluctuation in the treadmill