Toggle power switch is not moving. Can't get body separated
The toggle power switch on my Acme challenger is not moving. I am a fairly handy. I have loosened the center nut on the bottom and am trying to get four screw out of the rubber foot area. At this point though the base is not separating from the mid section. What can I do?
Juicers - Acme - 6001 Juice Extractor
Answers & Comments
THE CENTER NUT IS A LOCKING NUT TO
SECURE SET SCREW THAT LOWERS AND
RAISES THE MOTOR TO ADJUST CHUTE TO
BLADE GAP. THE 4 SCREWS RELEASE THE
BASE WHICH MUST BE JUICED TOGETHER.
KEEP TRYING IT WILL COME APART. ORDER
NEW SWX FROM WARING AT 800 492 7464.
DID NOT REALIZE WAS AN OLDER ACME WITH A TOGGLE SWX.
IF WARING CAN'T PROVIDE TRY AND MATCH IT UP AT
RADIO SHACK. THE ADJUSTMENT FOR THE CENTER NUT IS
TO RAISE THE MOTOR TILL BLADE CONTACTS CHUTE, THEN
BACK OFF A HALF TURN. DO THIS WITH JUICER FULLY
ASSEMBLED. ALSO BY JUICED TOGETHER I MEANT STUCK.