Troble shoot aiwa 20gt33
When power switch is going to ON it will energize,but just in seconds only and back to stanby. The relay will automatically off thats why it will not energize the circuit,i found no short circuit between power supply and horizontal.
Televison & Video - Aiwa
Answers & Comments
Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor. Check the input voltage to LOT. If the voltage is absent check the feeder resistor; if any. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
Type in this key phrase " my service table today " in the search box at the top right of the display window of the home page, to get gathered some pages which has the details of practical experiences to the author of that site.