Trying to replace key lock cylinder but couldn't find any pin or knob to push to release cylinder, I removed plastic cover under and top of steering still nothing at sight
Disconnect the battery then put the switch in the run position look closely for a small hole in-the face of the lock cylinder use a 1/8 drill bit or a straightened out paper clip to push in on the lock pin and jiggle the switch out. I hope this helps. Take care.
Answers & Comments
Disconnect the battery then put the switch in the run position look closely for a small hole in-the face of the lock cylinder use a 1/8 drill bit or a straightened out paper clip to push in on the lock pin and jiggle the switch out. I hope this helps. Take care.