For that you need to RESET it. 1. Connect the EOC-3220 to your computer with a null modem serial cable.
2. Start a HyperTerminal session: Click Start and then select Programs -> Accessories -> Communications -> HyperTerminal.
3. After the HyperTerminal window appears: a. Give this new connection a name. Ex: EOC-3220. b. Select correct COM port. Ex:COM1. c. Set baud rate as "38400", data bits "8", parity "none", stop bits "1", and flow control as "None". Then press “OK” to bring up the HyperTerminal window. d. Unplug the power on the POE injector and wait 5 seconds then plug the power back in.
4. Wait until the "#" is displayed in the HyperTerminal window.
5. Type "flash reset", then hit enter.
6. Type "reboot", then hit enter. After the device reboots, all settings will be at factory default. then configure it again. Also uninstall wireless lan driver from computer then reinstall. You can uninstall it from device manager and control panel->add remove programs. Let me know if you need further assistance. Thanks for using FixYa.
No lan driver installed. Using the web browser interface. I have 2 of these units and just updated the firmware to 1.43.05. Both were successful on the updates. One unit reset correctly but this one is giving me the error.No lan driver installed. Using the web browser interface. I have 2 of these units and just updated the firmware to 1.43.05. Both were successful on the updates. One unit reset correctly but this one is giving me the error.
Answers & Comments
For that you need to RESET it.
1. Connect the EOC-3220 to your computer with a null modem serial cable.
2. Start a HyperTerminal session: Click Start and then select Programs -> Accessories -> Communications -> HyperTerminal.
3. After the HyperTerminal window appears:
a. Give this new connection a name. Ex: EOC-3220.
b. Select correct COM port. Ex:COM1.
c. Set baud rate as "38400", data bits "8", parity "none", stop bits "1", and flow control as "None". Then press “OK” to bring up the HyperTerminal window.
d. Unplug the power on the POE injector and wait 5 seconds then plug the power back in.
4. Wait until the "#" is displayed in the HyperTerminal window.
5. Type "flash reset", then hit enter.
6. Type "reboot", then hit enter. After the device reboots, all settings will be at factory default.
then configure it again.
Also uninstall wireless lan driver from computer then reinstall.
You can uninstall it from device manager and control panel->add remove programs.
Let me know if you need further assistance.
Thanks for using FixYa.
tried the reset, but I cannot get "#" prompt keeps repeating:
Tx hangup! Reset wlan driver [1]...
Tx hangup! Reset wlan driver [2]...
No lan driver installed. Using the web browser interface. I have 2 of these units and just updated the firmware to 1.43.05. Both were successful on the updates. One unit reset correctly but this one is giving me the error.