Start a HyperTerminal session: Click Start and then select Programs -> Accessories -> Communications -> HyperTerminal. c. Set baud rate as "38400", data bits "8", parity "none", stop bits "1", and flow control as "None". Then press "OK" to bring up the HyperTerminal window.
Answers & Comments
Start a HyperTerminal session: Click Start and then select Programs -> Accessories -> Communications -> HyperTerminal. c. Set baud rate as "38400", data bits "8", parity "none", stop bits "1", and flow control as "None". Then press "OK" to bring up the HyperTerminal window.
Hi!
You can reset your username and password by restting the EnGenius EOC-3220 by resetting it as factory default settings which is as under:
IP Address: 192.168.1.1 (Client Bridge mode)
Username: admin
Password: admin
Please do accept this solution and revert for further assistance.
Thanks
Rylee
Hi Rylee,
I have the same problem and after the factory default UN : admin and PWD : admin not working. Kindly advice.
Thanks for the same in advance..