Vestax pdx 2000 motor problem
Hi i accidentaly turned my turntable on without the platter attached and now the thing is all out of wack!! any reset sequences??
i think it screwed with the tach calibration..
Audio Players & Recorders - Vestax - Pdx2000 Direct Drive Turntable System
Answers & Comments
This is a really common fault with this model of TT. I've just repaired a pair of them with the same problem.
You need to remove the bottom cover of the deck then take the round cover off the bottom of the motor assembly. Be really careful with that, delicate sensitive stuff inside. Once you remove the screws use a small flat blade screwdriver to lift it free of the rubbery glue that seals and holds it in place.
Once removed, in the centre of that cover is a small black rubber cirlce about 6mm in diameter that the shaft of the motor rotates on. The problem causing all of that erratic platter movement is with this small black circle.
The solution I found was to use double sided tape to hold this part in place. This serves two purposes. First, to stop the part from moving off its required location, Secondly, to raise the part up slightly from the bracket that it sits on. Layer the double sided tape up so its the around the same thickness as the small black rubber circle. Then place the black cirlcle into its original location bedding it firmly into the tape.
A tiny small dolop of grease on the end of the motor shaft. Replace the motor and bottom covers. Bingo! The decks a-go-go!
Happy mixing!
thanks padster!!! it worked 100% without the tape. the black rubber was loose from the metal so i superglued it and bang! working normal again!
can you send some pics of it? got the same problem too, the platter is goin crazy, it spins back and forward, thanks!
Hi i have the same issue .However the small disc was broken and has since been lost .
What would you recommend to use instead.
Eg would a coin work or somethong similar?
anyone???????????????????/
Is there anyway of actually calibrating a pdx2000 motor or pitch , as i think mine might be out of calibration as they seem to drop out of sync??