Hi there,

Well it's a firmware update message, you need to upgrade the firmware of your Homecast HT9200DTR, please follow the below link to get the latest firmware -

http://www.dtvs.co.nz/images/firmware/ht9200dtr/01006A.zip

Instructions on how to install the software are below:

1. Download and extract the file "_sw_code.sgn" to the root drive of your USB memory key.
2. Insert the USB memory key in the USB slot (behind the front panel)
3. Press the Menu button on the Homecast remote control.
4. Press the "right arrow" button on the Homecast remote until you are at the "Advanced" menu option.
5. Press the "down arrow" button to highlight "USB Transfer" and the press OK
6. You will see three panels. The left hand side will show what the current software version is. The middle should show 1.01.2B.
7. Press the OK button.
8. The software will start loading and the receiver will reboot.
9. After the receiver restarts, press the Menu button again and go to the "Information" option and press OK.
10. Check the "S/W Version" is now 1.01.2B.
11. Perform a Factory Reset and then reload the channels.

Hope it helps.......

Good Luck!!

Thanks