Water was split on my Dish Network UHF Remote and when I push one the function keys all function keys light up for about 10 seconds and then it doesn't work anymore. It wasn't a lot of water just a little does anyone know how I can fix the problem?
Televison & Video - DISH Network - IR Remote Control
Answers & Comments
Remove the batteries and place the remote in front of the hair dryer focusing on the keypad and the battery storage area. After ten minutes all of the residual water should have evaporated that was trapped between the keypad and the circuit board. Replace the batteries and try the remote again.
If this does not resolve the issue you should call for a replacement remote.
Thanks for using Fix Ya.com