We have an LG WM3270CW front load washer that when you turn it on everything lights up but when you hit start nothing happens. No error codes and we can't put it into test mode either. Any ideas?
The first thing that happens when you hit start is: 1. Door is locked, did it lock? 2. Drain pump is activated for 30-60 seconds. 3. Load measurement (drum spins slowly) 4. Water intake level 1 and level 2 and so on...
Check doorlock first, then drain, then water intake. I think your lock is the problem
Answers & Comments
The first thing that happens when you hit start is:
1. Door is locked, did it lock?
2. Drain pump is activated for 30-60 seconds.
3. Load measurement (drum spins slowly)
4. Water intake level 1 and level 2 and so on...
Check doorlock first, then drain, then water intake.
I think your lock is the problem