Weedeater just quit starting,this is my other weedeater. it sounds like thewre is no spark,but spark plug is fine,how can you adjust the settings,might be out of whack
This is a murray weedeater,briggs and statton engine,almost two yrs old,new gas,plug,all cleaned,but i don't know how to adjust settings.
Garden - Murray
Answers & Comments
Hello again Joyce.
Do exactly what I say and you will save yourself money in the future
Find the carburetor... look for 2 adjustment needles. If there is a red and white plastic caps on them, remove them, throw away. Theye are put on by the factory for epa reasons only.
Have a flashlight handy... on the carburetor look for a H and an L... these are the high and low needles...
To adjust the low, which is only for idle only... start the unit up , let it idle, if it's not idling well, then adjust the L needle in quarter increments only...
The H needle you adjust while holding in the trigger while turning the needle in quarter increments...
So to start off, turn both clockwise units snug not super tight... then back both out 1 whole rotation.
This is your starting point...now you can proceed to adjust as needed....
that it is part of the problem,i can't get it started,it sounds like it doesn't have any gas ,but i put fresh gas and it is going to carb,thank you about the adjustments,i think i could adjust if i could get it started
Yes here is what to do to get started... get carburetor spray, spray some in the plug hole, put plug back in...Spray some as well in the carb. It will run, for a few seconds at least... but this is why you need to adjust the L needle... that's the one to help get it started.. screw the throttle screw in some more as well, that will also help get ya started.. the L needle is the key here.. I know what you are saying and this is what you need to do. It's totally a carburetor issue.