There is a wire that breaks that is located inside of the pivot arm that hooks to the limit switch. (If you take off the back look on the RIGHT side of the machine.) When that breaks, the weight will not adjust. I extended and rerouted my wires to run on the outside of the arm instead of the inside where they get nicked or broken by the moving parts.
Answers & Comments
There is a wire that breaks that is located inside of the pivot arm that hooks to the limit switch. (If you take off the back look on the RIGHT side of the machine.) When that breaks, the weight will not adjust.
I extended and rerouted my wires to run on the outside of the arm instead of the inside where they get nicked or broken by the moving parts.
When turned on and increasing the weight, the digital numbers increase, but the weight doen't change.
I will sell you the board off mine. email me at [email protected]