Just press UP/DOWN at the same time quickly. If you hold them down you will get to the menu but just pressing them and releasing them will turn the station back on.
Found the solution!! Step 1) Turn unit off. Hold 1, 3, up and down. Turn unit on. Wait till you see -1-, -2-. Then release the buttons. Step 2) Hold again 1 , 3, up and down. Wait thill you see FCC, FSE. Release the buttons and press the up button. Your system on now resetted and will heat again.
Try pressing I, III, Up, Down simultaneously until FSE appears in the display (Factory Settings Enabled) that fixed the same problem for me. Probably it is just some setting that is wrong.
Answers & Comments
Just press UP/DOWN at the same time quickly. If you hold them down you will get to the menu but just pressing them and releasing them will turn the station back on.
Found the solution!!
Step 1) Turn unit off. Hold 1, 3, up and down. Turn unit on. Wait till you see -1-, -2-. Then release the buttons.
Step 2) Hold again 1 , 3, up and down. Wait thill you see FCC, FSE. Release the buttons and press the up button.
Your system on now resetted and will heat again.
Try pressing I, III, Up, Down simultaneously until FSE appears in the display (Factory Settings Enabled) that fixed the same problem for me. Probably it is just some setting that is wrong.
On my solder station I can not even get the FSE to display.