When i start the dishwasher, there is a humming sound but there is no water coming into the dishwasher to wash. model number is: G1924-160, it was bout in april 2000. only one problem since, in 2005 where the pump was tested and the debris was removed
Based on your description, "there is a humming sound but there is no water coming into the dishwasher to wash"...the issue is likely with the inlet/water valve. I'm not sure if you are aware of it, but this machine is built by Bosch (B/S/H/).
**To remedy this you will need to check and possibly replace the valve** This is what to look for..i.e.
As long as your model number is indeed correct, this info below will be accurate.
Original part is # 425458. It usually retails for about $20 - $30USD at places such as "searspartsdirect.com" "repairclinic.com" to name a couple.
**Before attempting to repair the unit please turn off the power and the water supply to the dishwasher...safety first**
If you remove the lower kick plate/toe panel, you will see the inlet valve to your left...
i.e.
Replacing it or to check for debris in the filter/screen at the inlet is pretty straight forward. Here`s how...
1) undo the water line. ( here you can visually inspect the screen in the valve...if nothing noted, you'll likely need to replace it as follows )
2) Remove the two #20 torx screws fastening it in place.
3) the feed tube to the machine at the back of the valve when i start the dishwasher, - 5937279.jpg with the new one.
and
Once the new one is in you should be good to go. Let me know if you need any further assistance, otherwise good luck.
Hi, we have the same problem, different model. Model # GM 915-710. What should we do?Hi, we have the same problem, different model. Model # GM 915-710. What should we do?
Answers & Comments
Hello, welcome to FixYa.
Based on your description, "there is a humming sound but there is no water coming into the dishwasher to wash"...the issue is likely with the inlet/water valve. I'm not sure if you are aware of it, but this machine is built by Bosch (B/S/H/).
**To remedy this you will need to check and possibly replace the valve**
This is what to look for..i.e.
As long as your model number is indeed correct, this info below will be accurate.
Original part is # 425458. It usually retails for about $20 - $30USD at places such as "searspartsdirect.com" "repairclinic.com" to name a couple.
**Before attempting to repair the unit please turn off the power and the water supply to the dishwasher...safety first**
If you remove the lower kick plate/toe panel, you will see the inlet valve to your left...
i.e.
Replacing it or to check for debris in the filter/screen at the inlet is pretty straight forward. Here`s how...
1) undo the water line. ( here you can visually inspect the screen in the valve...if nothing noted, you'll likely need to replace it as follows )
2) Remove the two #20 torx screws fastening it in place.
3) the feed tube to the machine at the back of the valve when i start the dishwasher, - 5937279.jpg with the new one.
and
Once the new one is in you should be good to go. Let me know if you need any further assistance, otherwise good luck.
Thanks for visiting FixYa.
Regards,
Macmarkus :)
Hi, we have the same problem, different model. Model # GM 915-710. What should we do?