When i turn on my furance it starts up later it will try again and the system will lockout with one flash on the board indicating retries recycles exceeded any ideals?
if the furnace comes on, you may have a flame sensor that needs cleaning. it's the silver rod looking thing shaped like an "L" in front of one of the burners. see if you can disconnect it and take a wire brush to it and try to get it back to silver if it's black.if the furnace comes on, you may have a flame sensor that needs cleaning. it's the silver rod looking thing shaped like an "L" in front of one of the burners. see if you can disconnect it and take a wire brush to it and try to get it back to silver if it's black.
the ignitor isn't itermittant, it either comes on or doesn't. you may have a control board failure. if the flame sensor isn't "sensing" the unit will shut down. do the burners light at all?the ignitor isn't itermittant, it either comes on or doesn't. you may have a control board failure. if the flame sensor isn't "sensing" the unit will shut down. do the burners light at all?
Answers & Comments
Check to make sure the gas is on and the flu pipe is clear. does the draft motor come on at all? if not, you may have a failed control board.
if the furnace comes on, you may have a flame sensor that needs cleaning. it's the silver rod looking thing shaped like an "L" in front of one of the burners. see if you can disconnect it and take a wire brush to it and try to get it back to silver if it's black.
the ignitor isn't itermittant, it either comes on or doesn't. you may have a control board failure. if the flame sensor isn't "sensing" the unit will shut down. do the burners light at all?