2) Use your calibration software by easy diagnostic and fix it.
3) Tight the flexible cord from key piney vs display board. 4) Tight the connector from display board vs, Main Motor board,
5)aTTACHED THE diagram for sensor reed switch adjusted by 1/8"
6) Test the main motor controller board for 115 Vca, +5vdc FOR OUTPUT GOING TO DISPLAY BOARD. 7) tEST THE transformer see the tips. 8) Test the power supply for +5Vdc see if there are some componnet like resistor, capacitor, diodes, etc Burns.
http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitnessSee the block diagram for easy diagnostic that I did for people like your. Sincerely. Happy New Year G-d bless you.
Answers & Comments
1) tRY TO exchange new batteries by news one.
2) Use your calibration software by easy diagnostic and fix it.
3) Tight the flexible cord from key piney vs display board.
4) Tight the connector from display board vs, Main Motor board,
5)aTTACHED THE diagram for sensor reed switch adjusted by 1/8"
6) Test the main motor controller board for 115 Vca,
+5vdc FOR OUTPUT GOING TO DISPLAY BOARD.
7) tEST THE transformer see the tips.
8) Test the power supply for +5Vdc see if there are some componnet like resistor, capacitor, diodes, etc Burns.
http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitnessSee the block diagram for easy diagnostic that I did for people like your. Sincerely. Happy New Year G-d bless you.
ernesto cuadra
managua, nicaragua,