When pushing trigger it starts then stops quickly
Snap On Plasma A25
Its brand new, I have use it just a couple of times. When pushing trigger it starts then stops quickly or makes a clunk and stops. Sometimes when I push the trigger another 3 or 4 times it starts again. Could it be low voltage it is only a 110 plug in Thanks.
Its brand new, I have use it just a couple of times. When pushing trigger it starts then stops quickly or makes a clunk and stops. Sometimes when I push the trigger another 3 or 4 times it starts again. Could it be low voltage it is only a 110 plug in Thanks.
Welding Tools - Miller - Spectrum 375 Cutmate Plasma Cutter 903891
Answers & Comments
If its on an extension cord then definitely. You need to run those on 220-240 or use s super short cord. Make sure you have good airflow too.