When setting the temperature of either oven, the digital display dims and comes unreadable after a few seconds. The Time display also becomes unreadable. The ovens DO reach the proper temperature, but the only way the temperature is indicated is by the soft "beep'. If you don't hear that, your have NO IDEA what is going on or what time it is. One oven light is burned out, (top oven unit, left side). We have not replaced it yet but will do so this morning. Other than that, we have no idea as to how to fix it. There is no indication in the Owner's Guide as to where to even start or if some control was turned on by accident. Therefore, we are clueless!
This seems to be an issue with the display going bad. Please check the ribbon cable to the display, confirm it is fixed firmly and not cut. If cable seems to be fine then unplug the oven for 1-2 hours and check, else you may need to replace the display. Hope this helps... Please post back if you need more information. Daniel
After you take out the control panel you will see the ribbon cable connecting both the control panel and the power board take that out and clean the board....you can also blow air on the board....if this wont solve the issue then yes service call is required if you are not comfortable replacing it yourselfAfter you take out the control panel you will see the ribbon cable connecting both the control panel and the power board take that out and clean the board....you can also blow air on the board....if this wont solve the issue then yes service call is required if you are not comfortable replacing it yourself
Answers & Comments
Hi
This seems to be an issue with the display going bad. Please check the ribbon cable to the display, confirm it is fixed firmly and not cut. If cable seems to be fine then unplug the oven for 1-2 hours and check, else you may need to replace the display. Hope this helps... Please post back if you need more information.
Daniel
After you take out the control panel you will see the ribbon cable connecting both the control panel and the power board take that out and clean the board....you can also blow air on the board....if this wont solve the issue then yes service call is required if you are not comfortable replacing it yourself